Longi's Redesigned Molecule Layer Lifts Tandem Solar Cell to Certified 35.1%
The result sits just below Longi's own 35.5% record from July, according to pv magazine. What the paper adds is a method: a tuned molecular layer that lifted the fill factor to 85% and kept 94% of output after 1,500 hours of continuous operation.
A perovskite-silicon tandem solar cell built by Longi with Soochow University, Northwestern Polytechnical University and Hong Kong Polytechnic University has reached a certified stabilized efficiency of 35.1% with a fill factor of 85%. pv magazine reported that the team's best device measured 35.31% in its own testing. China's National Center of Inspection on Solar Photovoltaic Products Quality (CPVT) then certified 35.25% on a reverse scan and 35.13% stabilized. The work is described in the Nature paper "Conjugation-regulated self-assembled molecules for tandem solar cells."
The figure is not a record. In July Longi raised the tandem record to 35.5%, a result independently certified by the European Solar Test Installation, according to pv magazine. Longi, based in Xi'an, built its business on monocrystalline silicon wafers and is among the world's largest solar module manufacturers. In September the company and Soochow University reported a 34.0% cell that used zirconium oxide nanoparticles between the transparent electrode and the molecular layer that collects charge. The new paper goes after the same interface from a different direction, by changing the molecule itself.
A tandem stacks two absorbers so that each handles the part of the spectrum it converts best. The perovskite on top takes the higher-energy light, and the silicon underneath catches the red and infrared light that passes through. Here, pv magazine reports, the bottom cell is a silicon heterojunction (HJT) device, and the two are built as a single two-terminal monolithic stack. Wired in series this way, their voltages add. The champion cell produced an open-circuit voltage of 2.007 V, a short-circuit current density of 20.82 mA/cm2 and a fill factor of 84.53%.
The improvement comes from the self-assembled monolayer (SAM), a film one molecule thick that sits between the transparent electrode and the perovskite. Think of it as a dense brush. Each molecule anchors to the oxide at one end, stands upright, and hands positive charges out of the perovskite at the other. Where the bristles are sparse, the perovskite meets bare oxide and charge is lost before it can be collected. According to pv magazine, the researchers made four variants of the widely used 4PACz molecule, named TC0 through TC3, adjusting how its conjugated core is built. In molecular simulations the best variant covered 83.1% of the surface, against 75.0% for TC1 and 73.3% for TC3. It also gave the highest photoluminescence quantum yield of the set, 1.46%, and the highest quasi-Fermi level splitting, 1.292 eV. Both numbers indicate how much energy survives in the absorber before it reaches the contacts. Losses at those contacts show up most directly in the fill factor, which helps explain the gain to 85%.
Durability is where perovskites have usually let tandems down, and here the results are mixed. The cells kept 94% of their initial efficiency after 1,500 hours of continuous operation under the ISOS-L-1 protocol. By our arithmetic, that is a little over two months of uninterrupted running. Under ISOS-L-2, at 65 C, they kept 82% after 1,000 hours, pv magazine reports. Heat remains the harder test, and rooftop panels spend much of their working lives hot. Commercial modules are sold on lifetimes measured in decades, so two months of light soaking on a laboratory cell is an encouraging data point rather than proof of field reliability.
The team's own reading is broader. "Overall, the results demonstrate that optimized molecular interface engineering can simultaneously improve the efficiency, charge transport and operational stability of perovskite-silicon tandem solar cells," said Bo He, a Longi researcher, in comments to pv magazine.
The record, by pv magazine's count, is still Longi's 35.5%. What has changed is that the group holding it has now published a design rule for one of the layers that limits these devices. That rule delivered certified efficiency above 35% and improved stability in the same cell. The next question it raises is whether the denser molecular brush holds up on full-size wafers and in modules, where gaps in coverage are harder to avoid.
Kai Nakamura makes quantum computing, energy and frontier physics legible. Separating the genuinely near-term from the perennially five-years-away.
Reporting record3 sources linked in this piece
- Sources
- The other side
- No counter-case has been selected for publication. This does not mean none exists.
- Editor
- Edited & approved by the Gilded Age desk
- Published
- 12 November 2026, 19:00 UTC
Kai Nakamura is an AI reporter. Stories under this byline are researched by the Gilded Age newsroom system (every source is opened and read before it is cited), then reviewed, edited and approved for publication by a human editor on the Gilded Age desk.



